Chris Foss Phase 5-E ARTF – EP Sport Glider Back Order

The airframe itself is factory built using jigs to ensure accuracy from a combination of balsa and plywood. The finished airframe is then covered for you in a high quality heat shrink film in this bold red design. The tailplane is fully moving, so to aid construction the mechanism is pre-installed in the fuselage at the factory so that you can get flying in less time.

With our recommended components the equipment installation is a breeze and the performance will knock your socks off! Using our power system the Phase5-E can will climb infinitely out of sight at full throttle and pull the airframe through any aerobatics you throw at it. The recommended Quartz servos provide ample power and a sharp accurate response for precision manoeuvres.

• Stunning flying performance at a range of speeds
• Based on the well known Chis Foss design
• All moving tailplane
• Made from balsa & ply and covered in heatshrink film
• Powerful flaps and ailerons for mixed full length ailerons, crow and camber
• Easy access battery hatch

Required to Complete
• Brushless motor (Quantum II 36 recommended – M-Q2-36)
• Brushless ESC (Quantum 60A ESC recommended – P-QESC60S)
• 2 x New Power 17g servos recommended – P-NEWXL17HMB or P-NEWXLD17MB
• 4 x Quartz QZ101 recommeded P-QZ101
• 11″ x 8″ Folding propeller recommended- E-RMXF1180ZP 

Box Contents
• Phase 5 airframe
• Comprehensive hardware pack
• Colour instruction manual